SKKA-SWT-1200
Stainless Steel Work Table
Braced work top with undershelf and adjustable levelling feet. Turned down or marine edge, welds ground and blended. Custom sizes to your layout.
SKKA Stainless / Tables and furniture
Stainless steel work tables, sink units and laboratory furniture
Work surfaces built for washdown areas, production floors and laboratories. Braced tops that do not drum under load, turned-down or marine edges, welded sink bowls with proper fall to the dr…
Tables and furniture
5 product lines, each with a full technical sheet.
Work surfaces built for washdown areas, production floors and laboratories. Braced tops that do not drum under load, turned-down or marine edges, welded sink bowls with proper fall to the drain, and sealed adjustable levelling feet that do not trap water underneath.
Standard sizes are shown on each technical sheet, but almost every table we make is a custom size. Send the length, depth and working height you need along with any backsplash or undershelf requirement and we quote against it.
How these are built
Details that decide whether it lasts.
Braced tops
Underside bracing sized to the span so the top stays flat under working load instead of flexing and drumming.
Welded, not clipped, sink bowls
Bowls welded in and ground flush, with fall to the drain. No silicone joint that goes black in six months.
Sealed levelling feet
Adjustable feet sealed at the leg so water cannot sit inside the tube. Important in any washdown area.
Ground and blended welds
Every weld that will be cleaned is ground flush and blended, then pickled and passivated.
Common questions
What buyers ask about tables and furniture.
Can I get a work table in a non-standard size?
Yes, and most of our tables are. Give us length, depth and working height, plus whether you need a backsplash, undershelf or castors, and we build to that.
What thickness is the table top?
Typically 1.2 to 2.0 mm with underside bracing sized to the span. Heavier gauges are available where the duty needs them - tell us the intended load and we engineer against it.
Do you supply tables with castors instead of legs?
Yes. Fixed legs with levelling feet, castors with brakes, or a combination of two fixed and two swivel, whichever suits the application.
Are these tables suitable for a GMP cleanroom?
They are suitable for cleanroom furniture and non-product-contact duty. Product-contact surfaces requiring mirror polish to a specified Ra value with full surface documentation are outside our present scope, and we say so at quotation rather than after the order.
Request a quotation
Send a drawing, or a catalogue code.
Quote any code from this page with your quantity and required size, or send your own drawing as PDF, DWG or STEP. We come back with a price, a lead time and any question we have about the specification.
If an item falls outside what we can properly deliver, we will say so in the same reply.
- CompanyShree Krishan Kirpa Associates
- ContactYatul Gupta, Managing Director
- Telephone / WhatsApp
- Email
- WorksHSIIDC Industrial Estate, Manakpur,
Yamuna Nagar, Haryana, India